Stereo Speaker Setup

1. Overview

   

   This hookup method is used for an extended Dolby Digital surround sound speaker setup, which consists of seven main speakers and a subwoofer for low bass reproduction. It is also used for the playback modes available on some A/V receivers that process stereo audio sources, such as CDs and MP3s, into simulated surround sound.

   In this setup, you'll connect a total of eight speakers to your A/V receiver or preamplifier — left, center, right, left side and right side, left rear and right rear; plus a subwoofer for low bass.

2. Step 1: Prepare The Speaker Wire

   

   Make sure you have enough speaker wire to reach from your A/V receiver to each speaker (except the subwoofer). Speaker wire, which is sometimes also called "zip cord" or "lamp cord," is available either in pre-cut lengths, or in spools where you can cut strands to whatever length you need. The thickness of the wire is called the "gauge", which is measured by a number — the smaller the number, the heavier the wire (gauge). For most audio systems, we recommend 20 or 18 gauge speaker wire. For long wire runs (more than 50 feet per speaker), 16 gauge wire is a good choice.

3. Step 2: Strip The Ends Of The Wire

   

   Note the white stripe on one conductor to help distinguish plus (+) from minus (–)

   Notice that your speaker wire has dual strands, or conductors running through it. One of these is the "positive" (or "plus") conductor, and the other is the "negative" (or "minus") conductor. Both are needed for a speaker hookup, as virtually all speakers have both a plus and minus connection terminal. One of the wire's two conductors will be marked with a stripe or a ridge. This helps identify which side is plus and which is minus. It doesn't matter which conductor you use for plus or minus, as long as you're consistent — always connect plus to plus, and minus to minus. Separate the two conductors by peeling them apart, and strip away ¼" of the plastic insulation on each one, leaving bare wire at the ends.

4. Step 3: Connect Wire To The Speakers

   

   Using just the bare, stripped end of the wire, you'll connect one of the wire's conductors to the positive (plus) terminal on the back of the left front speaker, and then connect the other conductor to the negative (minus) terminal next to it. Remember to be consistent with plus and minus — red is usually the indicator for plus, and black is usually minus.

   If your speakers have a "post" type connection (top), loosen the plastic knob, wrap the bare wire around the metal post, and then tighten the knob to secure the wire. If your speakers have a "spring clip" type connection (bottom), press on the tab, insert the bare wire into the hole, then release the tab, which will spring back and secure the wire. Again, remember to be consistent with plus to plus and minus to minus.

   Repeat this step and connect speaker wires to each of the remaining six speakers — center, right front, left side, right side, left rear and right rear. You should now have plus and minus wire strands connected to seven of your eight total speakers.

5. Step 4: Connect Main Speakers To The Receiver

   

   To connect the main — left and right front — speakers to the receiver, you'll basically be repeating the process you just did for connecting wire to the speakers, only this time, you'll connect the other end of the wires to the appropriate terminals on the receiver.

   The back of most receivers will have speaker terminals that will be marked front left and right. Sometimes this will be labeled main left and right. Connect the plus end of the left speaker wire to the plus terminal of the left speaker connection on your receiver. Then do the same for the minus end. When you've done this, repeat the process for the right speaker.